Application product - Film-On

Film-On is the factory recommended application solution for tinted and untinted automotive window films. Film-On is also the recommended application solution for flat glass films with pressure sensitive adhesives (PSA), sputtered bronze films and silver based films. Its neutral pH formulation, together with the correct application solution mixture, will reduce the incidence of soap scum absorption into the adhesive film during the drying phase.

DO NOT USE DISHWASHER DETERGENT FOR GLASS FILM INSTALLATION.

User manual :

Using the dispensing device, place a container under the spout and depress the pump.

• It is recommended to mix :
• 3 ml (3 pumps) with 1 L of demineralised water ,
• 6 ml (6 pumps) with 2 L of demineralised water ,
• 12 ml (12 pumps) with 4 L of demineralised water .

It may be necessary to use up to twice the recommended amount of Film-On for high temperature or low humidity conditions.
Solution older than 48 hours should be discarded. Spray containers should be thoroughly rinsed before preparing new solutions.

DO NOT USE THIS PRODUCT TO CLEAN OR PREPARE (RAZOR OR SCRAPER) AUTOMOTIVE OR FLAT GLASS.

Need help with? Contact your Solaris Control distributor.

Cautions :

Lightly spray the diluted solution on the glass and avoid letting the concentrate or diluted solution remain on delicate surfaces, such as the interior or exterior of cars, marble surfaces, window sills, furniture or floors. Always drape delicate surfaces with absorbent cloths. Do not allow to freeze.

DO NOT INGEST. KEEP OUT OF REACH OF CHILDREN.

Safety data sheet available on request for the professional user.

Composition : Distilled water, peg-80 sorbitan laurate, cocamidopropyl betaine, sodium tricedeceth sulfate, peg-150 distearate, methylchloroisothiazolinone, methylisothiazolinone.